![]() ![]() Lift measured with 1.5 rocker add 7% for 1.6. ![]() These block casting are flat tappet without roller provisions:ġ0054727, 14079287, 14088548, and 14101148.īe careful reading the underlined casting numbers they are similar looking but are not the same block, one is provisioned, one is not.įor a roller block the GM cams that will work without reprogramming are:ĭurations measured at. These block castings are roller cam provisioned to some degree but for 1995 most likely have flat tappet cams from the factory:ġ0243880, 14011148, 14088526, and 14093638. Other blocks do not have these provisions and are not easily adapted to a roller cam, this requires you use a flat tappet cam or a retrofit roller kit. If drilled then tapping them isn't much of a problem. If these are present they may be drilled or drilled and tapped. If it is a roller block casting, it will have the bosses for the cam thrust plate inside the timing case, it will have the raised lifter blocks, and it will have the 3 bosses that retain the spider that posiitons the alignment bars which hold pairs of lifters in proper orientation to the cam. You need to check the block casting number to see if it is potentailly a roller cam block or not. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |